Anders Wang Nano plugging this product is a new high-efficiency inorganic moisture, permeability, sealing materials and excellent bonding material, plugging into quick-setting type retarding. Impermeability of two kinds, both Single component gray and black powder. ? Quick-setting plugging type: for impermeability, plugging, emergency repairs. Retarding impermeability type: for moisture, permeability, a large area of ??water. A,? The main features ◆ non-toxic, harmless, can be used for drinking water projects. ◆ rapid solidification fast and hard, and instantly seal, early strength, high strength, impermeability crack ◆ can bring water construction, rapid plugging, welcoming the dorsal surface construction can be. ◆ clotting time is adjustable, waterproof, adhesive can be. ? Second, the construction process 1, no seepage surface construction (retarding sealing agent) ?? (1) the base surface treatment: the base surface must be sufficiently moist to saturated (but no water), and require a solid, clean, smooth, asperities may be leveling with cement mortar. ?? (2) Ingredients: no seepage face should choose "retarding sealing agent", according to powder: water = 1: 0.3 at low speed stirring into a uniform lump-free paste. ?? (3) Construction: After primary treatment is good, with a scraper or trowel scraping pressure of the first layer retarding slurry coating sclerosis (hand Gently press without leaving fingerprints) after spraying timely maintenance. After 90 minutes, scraping pressure in the vertical direction of the second layer. Scraping pressure may be needed, the third layer. After all painted, wet curing for 48 hours (can be water, cover the wet, etc.). 2, seepage surface construction (quick-setting sealing agent) ?? (1) the base surface treatment: the base surface must damp, solid, clean, smooth, uneven density available at Nile quick-setting sealing agent plus twice the sand leveling , the base surface seepage serious diversion in place to fight the leakage of water holes and concentrated under reduced pressure leads. ?? (2) Ingredients: water seepage surface construction should be "quick-setting sealing agent." By powder: water = 1: 0.3 at low speed stirring into a uniform lump-free paste. Ingredients not too much time to avoid solidification wastage. ?? (3) Construction: After the base surface with a dry cloth to wipe away a layer of material quickly (if temporarily seepage pipe) with a trowel first; and so after hardening (shiatsu without leaving marks) dry surface, the The second layer of material; if there is a large area of ??water seepage, and then in the same way the first three layers of materials, if only a partial seepage water seepage at just add another layer until no leakage, then blocking water holes. Finally, 48 hours of wet curing (available water, cover the wet, etc.). 3, rapid plugging leaks mouth (quick-setting sealing agent) ?? (1) the base surface treatment: anti-hewn leaks horn holes, wipe the surface water to remove residue. ?? (2) Ingredients: Fast plugging must use "quick-setting sealing agent", the powder with water ratio of 1: 0.2 is repeated kneading into a group, sealing material by powder: water = 1: 0.3 and stir into uniform putty-like. ?? (3) Construction: the fast solidification of quick-setting type clumps rapidly leaking into the mouth, stick with a hammer smashing a real squeeze. After confirmation no longer leaking, the hole extended the range of around 10cm of Zaigua pressure layer, spray timely maintenance. Plugging the order should be plugging a small leak, and then blocking a large leak. ? Third, pay attention ???? a former construction grassroots moistened with water, after the construction of wet curing coating attention. ???? 2. Do not apply below 5 ℃ four, the reference amount ???? 2.0kg / m2- 2.5kg / m2