K11 flexible waterproof paint color (green) Anders K11 color flexible waterproof coating is a two-component polymer modified cementitious waterproofing materials. Polymer slurry is added by importing various additives compounds made with high bond strength, flexibility, and mildew, wear resistance; powder made from high quality cement, quartz sand and unique active substances, water Thereafter, a chemical reaction, infiltrated the inside of the structure, and the formation of crystals, not only the water in all directions by the repressor, and reinforcing the structure, extend its life. First, the characteristics of an advantage for the moisture, brushing the thickness of 0.6mm, approximately 0.6 kg / m2; 2, for water, brushing a thickness of about 1.2mm, about 1.2 kg / m21, can be applied over damp base surface. 2, strong bond with the substrate, the slurry of active ingredient may penetrate the cement-based surface pores, micro-cracks and chemical reaction. Integration with the substrate to form a layer of fine crystal waterproof layer. 3, after the slurry to dry mortar do not need a protective layer can be directly pasted tiles and other processes. 4, for the positive side or the back surface of the water, its water efficiency does not change. 5, the product material is mainly composed of inorganic materials, without the risk of aging, with a permanent waterproof effect. 6, good air permeability, the collective holding dry. 7, non-toxic, harmless and environmentally friendly production Second, the scope 1, indoor and outdoor concrete structure, cement wipe the bottom, interior and exterior, and the kitchen, the bathroom waterproofing. 2, factory buildings, water conservancy, food warehouses, tunnels, underground parking, floor walls, swimming pools, water tanks and other parts have a waterproof building a stable structure. Third, the technical indicators of doing GB / T23445-2009 standards. The use of methods 1, the first additive Stir into the container, then slowly pour the powder in water and stir to evenly without particles, no precipitation of the pasty. 2, the operation works to maintain intermittent stirring to prevent precipitation. 3, with a brush or brush brushing glue directly with the base surface, not vulnerability; for proof, brushing a layer; for water, brushing two to three. Brushing second layer should be staggered with the first layer brushing direction. V. Dosage: 1 for moisture, brushing thickness 0.6mm, approximately 0.6 kg / m2; 2, for water, brushing a thickness of about 1.2mm, about 1.2 kg / m; Anders waterproof, waterproof coating waterproof material Recruitment agents throughout the country's top ten brands